Hello Rob, when I will be further in the project I will have questions for you because I also want to print my wtc caps like you.
I started to learn how to use freecad. This is not obvious !!
1/144 Nautilus Typhoon 3d printed
Collapse
X
-
Hi everybody,
i'm begining to print the Nautilus Drydocks Typhoon in 1/144.
I use an Ender 3 printer with PLA+. I have place a new bed (magnetic PEI). This bed work very well !
I use the software "Cura" and the default profile for the Ender 3 and PLA with some changes :
-bed heating : 70 °C
-print temperature : 220°C
-infill : 100%
-layer height : 0.2mm
I have begin with small parts. I will place pictures when a hull part is printed.
sorry if there are any mistakes. I speak only French and I write just a little English.
Frank
Welcome to the forum! Looking forward to seeing the progress on your 1/144 Typhoon build!
Rob
"Firemen can stand the heat"Leave a comment:
-
1/144 Nautilus Typhoon 3d printed
Hi everybody,
i'm begining to print the Nautilus Drydocks Typhoon in 1/144.
I use an Ender 3 printer with PLA+. I have place a new bed (magnetic PEI). This bed work very well !
I use the software "Cura" and the default profile for the Ender 3 and PLA with some changes :
-bed heating : 70 °C
-print temperature : 220°C
-infill : 100%
-layer height : 0.2mm
I have begin with small parts. I will place pictures when a hull part is printed.
sorry if there are any mistakes. I speak only French and I write just a little English.
FrankTags: None
Leave a comment: